During Charge and Discharge cell count is displayed
Individual cell screen displayed after error message
Max Internal temp cut off raised to 90*C/194*F
Charge rate drops 15% when internal temp reached 82*C/179*F
Will continue charging at lower rate or until reaches 90*C/194*F, it will then pause until charger reaches 64*C/147*F then resume.
Balance On/Off locked out for cells count 5S-14S
Increase capacity to 99Ah
Charge Capacity limit raised to 125%
Individual cell voltage more than .30V will go into EB mode
Individual cell voltage more than .40V will not charge, error message to “battery needs service” / next shows individual cell screen
Balance Mode Only – charger will balance battery while hooked up and showing cell balance screen. Small dots will flash next to cells being balanced. Fan will run at low speed.
Pb charge and discharge table modified to give wider range of limits per voltage settings
Charger input voltage set above actual input, charger will no long show message and lock up. It will show message and allow user to change setting. However charger will not allow any functions until settings are corrected.
Bug in display when charging corrects display reading
Widened range at which Pb mode will charge 6/12/18 cell Pb
*Any questions or concerns please contact customer support 702-228-8883*
