TP1010C Software Updates FIRMWARE UPDATES FOR TP1010C IMPORTANT: BEFORE USING PGM-01 USB PROGRAMMER, CLICK HERE (DOES NOT APPLY IF USING PGM-V2). USB Programmer Driver for PGM-01 Download this first to install your PGM-01 USB Programmer. USB Programmer Driver For PGM-V2 Download this first to install your PGM-V2 USB Programmer. PGM-01/PGM-V2 USB Programmer Instructions Instructions to help you setup your USB Programmer. TP1010C V2.00D Update For PGM-01 Charge mode for LiFe (A123): Topoff charge: 3.65V per cell Over voltage error: 3.85V per cell Initial slow charge to 3.0V per cell LiFe (A123) recovory mode: 1.5V per cell Discharge voltage minimum 3.0V How to select LiFe (A123): Go to: Option->charge setting mode Press INC key until the LCD displays A123 charge mode. TP1010C V2.1A Update for PGM-01 Charge mode for A123 data: Topoff Charge: 3.65V per cell Over voltage error: 3.85V per cell Initaial slow charge to 2.4V per cell LiFe/A123 recovory mode: 1.5V per cell LiPo Recovery mode: 2.0V per cell TP1010C V2.5 UPDATE FOR PGM-V2 TP1010C V2.5 UPDATE FOR PGM-01 Added NiCd/NiMh/PB (SLA)/LiFe (A123) battery charge/discharge/cycle functions Up to 10 memory slots are independently assignable for each chemistry type LiFe (A123) top off voltage is adjusted to 3.65V/cell Added selectable 2-10 hour system timeout function The last cycle data of charge and discharge before an error interruption occurs can be viewed by pressing the [Sel] (Select) button. Discharge power factor added Added 1's decimal digit to the voltage display At boot up, the screen message now shows "Thunder Power RC" (used to show "Thunder Power") Recovery mode: Increased from C/4 to C/2 Increased from 60 minutes to 120 minutes All nomenclature that said "A123" now says "LiFe" NiMH and NiCd Delta Peak algorithms have been optimized to reduce/prevent issues of false peaking Improved error warning information   *Any questions or concerns please contact customer support 702-228-8883*