FPV Video TX

• HAM Radio license is required to operate
• 600mW (27dBm, +/- 1dBm) of clean output power
• SMA Antenna connector, with supplied 5.8GHz Rubber-duck antenna
• Frequencies: 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz
• Not affected by 2.4GHz R/C radios

The 600mW version of the 5.8GHz transmitter greatly increases the range of a 5.8GHz link, adding a margin of security over the 25mW version. Team up with a Duo5800 or Uno5800 receiver on the ground and enjoy noise-free video further than you can see your model.

• Channel button for easy changing
• Current channel display
• Channel memory function saves current channel after power-off
• Frequency band can be selected by user
• Very light and ultra tiny

This 32-channel FPV wireless transmitter and receiver combo uses the latest technology to give you a lightweight and small video transmitter. Another great feature of this 5.8GHz transmitter is that is comes with a pushbutton that you can use to set the channel. No more complicated switches to adjust to get the correct frequency. And the last used channel is always stored so you don't need to set the channel each time you turn your transmitter on.

This small but powerful 5.8GHz 200mW transmitter gives you a range of up to 2000m with just the stock antenna! And the advanced, built-in regulator allows the transmitter to accept a very wide power input range.

• Integrated camera and 25mW transmitter
• Excellent image clarity in all lighting conditions
• Enough signal range for small park flyers and quad racers
• Compatible with 5.8GHz Fat Shark headsets
• Assignable frequencies through servo port
• Requires 2S or 3S LiPo battery, sold separately
• Powered separately or through model's receiver
• Integrated power filter prevents motor and servo interference
• No 2.4GHz RC interference
• Installs in seconds

The VA2500 combines an FPV camera and a 25mW, 5.8GHz transmitter into a single unit no bigger than a thimble. Its signal range is ideal for small park flyers or racing quads and it can be powered separately or through the model's receiver. Powering it separately requires a 2S or 3S Li-Po battery. If powering it through the receiver, its integrated power filter will prevent interference from the model's motor and servos.

The VA2500 is compatible with all 5.8GHz Fat Shark headsets and can be installed in minutes. If your RC system has a spare channel, you can remotely change the frequency via a dial or switch on your transmitter.